Brother International HL-1070 Service Manual - Page 51
Fig. 3.17, Follow instructions below when installing the thermistor in the fixing unit.
![]() |
View all Brother International HL-1070 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Note: Follow instructions below when installing the thermistor in the fixing unit. • Place the cleaner felt of the cleaner ASSY under the heat roller. • Place the end of the thermistor on the heat roller. • Insert the boss1 of the thermistor into the hole of the fixing unit frame. • Do not place the thermistor on the boss2 of the fixing unit frame. , , Boss2 Thermistor Boss1 Cleaner ASSY Heat roller Fixing unit frame Fig. 3.17 (7) Remove the two screws. (8) Open the fixing unit cover along the open side of the fixing unit cover. Screws Fixing unit vr Pressure Roller Fixing unit cover Shaft Fixing unit frame Fig. 3.18 III-11
![](/manual_guide/products/brother-international-hl1070-service-manual-cb9796c/51.png)
III-11
Note:
Follow instructions below when installing the thermistor in the fixing unit.
• Place the cleaner felt of the cleaner ASSY under the heat roller.
• Place the end of the thermistor on the heat roller.
• Insert the boss1 of the thermistor into the hole of the fixing unit frame.
• Do not place the thermistor on the boss2 of the fixing unit frame.
Fig. 3.17
(7)
Remove the two screws.
(8)
Open the fixing unit cover along the open side of the fixing unit cover.
Fig. 3.18
Screws
Fixing unit cover
Shaft
Fixing unit
vr
Pressure Roller
Thermistor
Boss2
Fixing unit frame
Heat roller
Boss1
Cleaner ASSY
Fixing unit frame