Brother International JX2517 Users Manual - English and Spanish - Page 17
as shown in the following illustration. - threading
View all Brother International JX2517 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
While holding the thread from the spool 5 with your right hand, pass the thread Put the thread behind the guide above the 8 needle. toward you, in the groove on the thread guide. • The thread can easily be passed behind the needle bar thread guide by holding the 1 • Make sure that the spring in the groove catches the thread. thread in your left hand, then feeding the thread with your right hand. 1 1 Spring Feed the upper thread as shown in the 6 following illustration. 1 4 2 1 1 Needle bar thread guide 53 Make sure you guide the thread through 7 the thread take-up lever from right to left as shown in the following illustration. 1 Thread the needle from front to back 9 leaving a thread tail of about 5 cm (2 inches). 1 1 Thread take-up lever Memo ● If the thread take-up lever is lowered, the upper thread can not be wrapped around the thread take-up lever. Make sure you raise the needle by turning the handwheel toward you (counterclockwise) so that the mark on the wheel points up. 1 1 5 cm (2 inches) Note ● Make sure you raise the presser foot lever and the thread take-up lever before you feed the upper thread. ● If you incorrectly feed the thread you may cause sewing problems. 16