Brother International JX2517 Users Manual - English and Spanish - Page 6

KNOWING YOUR SEWING MACHINE THE MAIN PARTS 3 2 1 4 B 5 A C 6 0 7 8 9 1 Bobbin winder (Page 11) This winds the thread onto the bobbin for use as the lower thread. 2 Spool pin (Page 11, 15) This holds the spool of thread. 3 Thread guide (Page 11, 15) This is used when winding the thread onto the bobbin and then threading the machine. 4 Thread take-up lever (Page 16) 5 Upper tension-control dial (Page 22) This controls the tension of the upper thread. 6 Thread cutter (Page 20) Pass the threads through the thread cutter to cut them. 7 Quick-set bobbin (Page 14, 17) (This is only available on certain models.) 8 Flat bed attachment with accessory compartment (Page 5) 9 Presser foot (Page 8) 0 Reverse sewing lever (Page 10) Push this lever to stitch in the reverse direction. A Buttonhole fine-adjustment screw (Page 28) B Pattern selection dial (Page 9) Rotate the dial in either direction to choose the stitch you want. C Handwheel Used to manually raise and lower the needle. D Main power and sewing light switch (Page 7) You can turn the main power and sewing light switch on and off. E Foot controller jack / socket (Page 6) Plug in the foot controller plug and connect the machine to the power supply. F Presser foot lever (Page 15) Used to raise and lower the presser foot. F D G E G Foot controller (Page 7) You can use this to control the sewing speed, and to start and stop sewing. Foot Controller: Model KD-1902 for 110-120V area KD-1902 for 110-127V area (Brazil only) Model KD-2902 for 220-240V area The foot controller part code differs depending on the country or region. Contact your dealer or the nearest authorized service center. Flat bed attachment The accessories can be stored in a compartment inside the flat bed attachment. Slide the flat bed attachment to the left to 1 open it. 1 2 1 Flat bed attachment 2 Storage compartment 5