Brother International NX570Q Operation Manual - Page 158
The stitch is
View all Brother International NX570Q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
APPENDIX Symptom Probable Cause Remedy Dust has accumulated in the feed dogs or in the bobbin case. Clean the race. A high-pitched noise is made while sewing. The upper thread was not threaded correctly. The bobbin case is scratched, or has a burr on it. Correct the upper threading. Replace the bobbin case. Contact your dealer or the nearest authorized service center. A bobbin designed specifically for this machine is not used. Incorrect bobbins will not work properly. Only use a bobbin designed specifically for this machine. The needle threader cannot be used. The needle has not been raised to the correct position. The needle is incorrectly installed. Press the "Needle Position" button. Correctly install the needle. The presser foot that is used is not Attach the presser foot that is appropriate for the type of stitch that appropriate for the type of stitch you wish to sew. that you wish to sew. The stitch is not sewn correctly. The thread tension is incorrect. Adjust the tension of the upper thread. The thread is tangled, for example, in the bobbin case. Remove the tangle thread. If the thread is tangled in the bobbin case, clean the race. The feed dogs are lowered. Slide the drop feed lever to the right. (as seen from the rear of the machine) The stitch is too short. Lengthen the stitch length. The presser foot that is used is not Attach the presser foot that is appropriate for the type of stitch that appropriate for the type of stitch you wish to sew. that you wish to sew. The fabric does not feed. The pressure of the presser foot is weak. Turn the presser foot pressure dial to the left to increase the pressure of the presser foot. The thread is tangled, for example, in the bobbin case. Remove the tangle thread. If the thread is tangled in the bobbin case, clean the race. Zigzag foot "J" is slanted on a thick seam at the beginning of stitching. Use the presser foot locking pin (black button on the left side) on zigzag foot "J" to keep the presser foot level while sewing. The sewing lamp does not come on. The sewing lamp is damaged. Contact your dealer or the nearest authorized service center. Nothing appears in The brightness of the LCD is either the LCD. too light or too dark. Adjust the brightness of the LCD. Reference page 142 page 28 - page 22 page 31 page 39 page 134 page 57 page 142 page 104 page 59 page 134 page 43 page 142 page 66 - page 159 156