Brother International NX570Q Operation Manual - Page 28
Installing the bobbin
![]() |
View all Brother International NX570Q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
GETTING READY Remove the bobbin from the shaft. q Press ("Needle Position" button) once or a twice to raise the needle, and then raise the presser foot lever. Turn off the sewing machine. b Slide the bobbin cover latch to the right. c 1 2 Memo z When the sewing machine is started or the handwheel is turned after winding the bobbin, the machine will make a clicking sound; this is not a malfunction. Installing the bobbin Install the bobbin wound with thread. CAUTION ● Use a bobbin that has been correctly wound with thread, otherwise the needle may break or the thread tension will be incorrect. ● The bobbin was designed specifically for this sewing machine. If bobbins from other models are used, the machine will not operate correctly. Use only the included bobbin or bobbins of the same type (part code: SA156, SFB(XA5539-151)). Actual size 11.5 mm (7/16 inch) This model Other model Memo z The order that the bobbin thread should be passed through the bobbin case is indicated by marks around the bobbin case. Be sure to thread the machine as indicated. a Bobbin cover b Latch X The bobbin cover opens. Remove the bobbin cover. d Hold the bobbin with your right hand and hold e the end of the thread with your left. • Be careful not to drop the bobbin. Insert the bobbin with your right hand so that f the end of the thread is on the left, and then, after pulling the thread firmly around the tab with your left hand as shown, lightly pull the thread to guide it through the slit. 1 a Tab CAUTION ● Be sure to install the bobbin so that the thread unwinds in the correct direction, otherwise the thread may break or the thread tension will be incorrect. 26
![](/manual_guide/products/brother-international-nx570q-operation-manual-81e98e1/28.png)