Brother International NX570Q Operation Manual - Page 34
When pulling out the thread, do not pull, it with extreme force, otherwise the, needle may break or
![]() |
View all Brother International NX570Q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
GETTING READY Lower the needle threader lever on the left d side of the machine until it clicks, and then slowly return the lever to its original position. 1 Raise the presser foot lever, pass the end of the e thread through the presser foot, and then pull out about 5 cm (2 inches) of thread toward the rear of the machine. a Needle threader lever X The thread is passed through the eye of the needle. Note z If the needle was not completely threaded, but a loop in the thread was formed in the eye of the needle, carefully pull the loop through the eye of the needle to pull out the end of the thread. 1 a 5 cm (2 inches) X The upper threading is finished. Now that the upper threading and the lower threading are finished, you are ready to begin sewing. Note z If the needle is not raised, the needle threader cannot thread the needle. Be sure to press ("Needle Position" button) to raise the needle before using the needle threader. CAUTION ● When pulling out the thread, do not pull it with extreme force, otherwise the needle may break or bend. 32
![](/manual_guide/products/brother-international-nx570q-operation-manual-81e98e1/34.png)