Brother International NX570Q Operation Manual - Page 29
Then, pull the thread toward you to cut it
![]() |
View all Brother International NX570Q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Memo z The order that the bobbin thread should be passed through the bobbin case is indicated by marks around the bobbin case. Be sure to thread the machine as indicated. The marks around the bobbin case differ depending on the model. Note z Make sure that the thread is correctly inserted through the tension-adjusting spring of the bobbin case. If it is not inserted correctly, reinsert the thread. 1 While lightly holding down bobbin with your g right hand as shown, guide the thread through the slit (1 and 2). • At this time, check that the bobbin easily rotates counterclockwise. Then, pull the thread toward you to cut it with the cutter (3). 1 a Tension-adjusting spring Reattach the bobbin cover. h Insert the tab in the lower-left corner of the bobbin cover, and then lightly press down on the right side. 2 2 3 1 a Slit b Cutter (Cut the thread with the cutter.) 1 X The lower threading is finished. Next, thread the upper thread. Continue with the procedure in "Upper Threading" (page 28). Memo z You can begin sewing without pulling up the bobbin thread. If you wish to pull up the bobbin thread before starting to sew, pull up the thread according to the procedure in "Pulling up the bobbin thread" (page 36). Winding/Installing the Bobbin 27
![](/manual_guide/products/brother-international-nx570q-operation-manual-81e98e1/29.png)