Brother International PE-DESIGN Ver.4 3 2 Instructin Manual for PE-DESIGN Ver. - Page 192
When every COM port is already in use for other peripherals, the following message appears.
View all Brother International PE-DESIGN Ver.4 3 2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 192 highlights
Contents Before Using Getting Started Design Center Layout & Editing 5 If the data cable between the card module and the computer or the power adaptor is disconnected while reading is in progress, reading will stop and this message will display: x Click OK to remove the message. Check all the connections and correct as necessary, then try again from the start. If the connections are correct, then a cable may be defective. Consult your dealer. 6 When every COM port is already in use for other peripherals, the following message appears. x Click Cancel to remove the message. Disconnect a peripheral connected to your computer and try again. 183 File Utility Programmable Stich Creator Quik Reference Alphabetic Index
183
Before Using
Design Center
Layout & Editing
File Utility
Programmable
Stich Creator
Contents
Quik Reference
Alphabetic Index
Getting Started
5
If the data cable between the card module and the computer or the power adaptor is disconnected
while reading is in progress, reading will stop and this message will display:
Check all the connections and correct as necessary, then try again from the start.
If the connections are correct, then a cable may be defective. Consult your dealer.
6
When every COM port is already in use for other peripherals, the following message appears.
Disconnect a peripheral connected to your computer and try again.
◆
Click
OK
to remove the message.
◆
Click
Cancel
to remove the mes-
sage.