Brother International PE180D Users Manual - English - Page 65
TROUBLESHOOTING, Trouble with thread and stitches - embroidery machine review
View all Brother International PE180D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
CONTENTS MACHINE KNOWLEDGE EMBROIDERING MAINTENANCE ERROR MESSAGE TROUBLESHOOTING Check for the cause of the problem without worrying. Whenever embroidering becomes difficult, review the section of the instruction book which explains the operation you are performing to make sure that you are using the machine correctly. If you still have difficulty, the following check list may help you correct it. If you still experience difficulties, contact your dealer or nearest authorized service center. Trouble with thread and stitches Symptom 1. Upper thread breaks 2. Lower thread breaks 3. Skipped stitches 4. Fabric puckers Probable cause Remedy 1. The upper threading is not correct. 1. Re-thread the upper thread. 2. The upper thread is tangled. 2. Clean the race or inner rotary hook. 3. The spool of thread is not correctly set. 3. Set the spool of thread correctly. 4. The correct needle is not used. 4. Change to the proper needle. 5. A thread other than the designated up- 5. Replace with the designated upper per embroidery thread is being used. embroidery thread. 1. The upper thread is tangled. 1. Clean the race or inner rotary hook. 2. The bobbin is not threaded properly in the shuttle. 2. Remove the bobbin, reset the bobbin properly and pull the bobbin thread through the channel. 3. A thread other than the designated 3. Replace with the designated lower lower embroidery thread is being used. embroidery thread. 1. The needle is not correctly inserted. 1. Set the needle properly. 2. The correct needle is not used. 2. Change to the proper needle. 3. The fabric has been placed in the embroidery frame incorrectly. 3. Place the fabric in the embroidery frame correctly. 4. The embroidery frame has been attached to the machine incorrectly. 4. Attach the embroidery frame to the machine correctly. 5. Thin or stretch fabric is being used with 5. Attach stabilizer fabric. no stabilizer fabric attached. 1. The upper thread tension is too strong. 1. Decrease the upper thread tension using the upper thread tension dial. 2. The upper or lower thread is not threaded correctly. 2. Thread the upper and lower threads correctly. 3. Thin or stretch fabric is being used with 3. Attach stabilizer fabric. no stabilizer fabric attached. 4. The fabric has been placed in the embroidery frame incorrectly. 4. Place the fabric in the embroidery frame correctly. 5. The correct needle is not being used. 5. Change to the proper needle. TROUBLESHOOTING PATTERNS EMBROIDERING USING A SMALL FRAME (OPTIONAL) EMBROIDERING USING A EXTRA-SMALL FRAME (OPTIONAL) EMBROIDERING USING A LARGE FRAME (OPTIONAL) 62