Brother International PE500 Users Manual - English - Page 83
Objects are placed near - tension problems
View all Brother International PE500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Symptom Probable Cause Remedy Reference Embroidery unit does not move. No pattern selected. The embroidery unit is not set up correctly. Select a pattern. Set the embroidery unit up correctly. page 50 page 19 The fabric is not fully stretched on the embroidery frame. The fabric is loose. Stretch the fabric properly on the embroidery frame. page 44 No stabilizer material is attached. Always use stabilizer material for embroidery. page 43 The thread is tangled and the bobbin case, etc., is plugged up. Remove the tangled thread. When the bobbin case is plugged up, clean the race. page 74 The thread tension is incorrect. Adjust the tension of the upper thread page 63, and the bobbin thread. page 64 3 The upper thread was not threaded correctly. Correct the upper threading. Make sure that the thread is hanged on the thread guide spring which is on the left side of the thread guide cover. page 38, page 39 The bobbin thread is incorrectly installed. Correctly install the bobbin thread. page 34 Embroidery not neatly done. Objects are placed near the carriage or embroidery frame. If the embroidery unit carriage or embroidery frame bumps into objects, the pattern will be misaligned. Do not place objects within the range of embroidery frame motion. page 58 Stretch the fabric on the frame once Material coming out of the again so that the material coming out embroidery frame is causing of the embroidery frame does not - problems. cause problems, rotate the pattern and embroider. If embroidery is done with the fabric A heavy fabric is being hanging off the table, the embroidery embroidered, and the fabric is unit movement will be impaired. - hanging off the table. Support the fabric while embroidering. The fabric is catching. It is Stop the machine and set the fabric - pinched. up correctly. The carriage was moved while the embroidery frame was being removed or attached during embroidery. If the carriage is moved during the process, the pattern may be misaligned. Be careful when removing or attaching the embroidery frame. - Troubleshooting 81