Brother International PE770 Users Manual - English - Page 31
Pass the thread through the slot as shown, and, then pull the thread out toward the front., Reattach - thread tension
UPC - 012502623489
View all Brother International PE770 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Pass the thread through the slot as shown, and f then pull the thread out toward the front. 1 1 a Cutter X The cutter cuts the thread. Note z Make sure that the thread is correctly inserted through the tension-adjusting spring of the bobbin case. If it is not inserted correctly, reinsert the thread. 1 a Tension-adjusting spring Reattach the bobbin cover. g Insert the tab in the lower-left corner of the bobbin cover, and then lightly press down on the right side. 2 1 X The lower threading is finished. Next, thread the upper thread. Continue with the procedure in "Upper Threading" (page 30). Memo z You can start embroidering without pulling up the bobbin thread. Winding/Installing the Bobbin 29
Winding/Installing the Bobbin
29
1
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
f
Pass the thread through the slot as shown, and
then pull the thread out toward the front.
a
Cutter
X
The cutter cuts the thread.
Note
z
Make sure that the thread is correctly
inserted through the tension-adjusting spring
of the bobbin case. If it is not inserted
correctly, reinsert the thread.
a
Tension-adjusting spring
g
Reattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover, and then lightly press down on
the right side.
X
The lower threading is finished.
Next, thread the upper thread. Continue with
the procedure in “Upper Threading” (page 30).
Memo
z
You can start embroidering without pulling
up the bobbin thread.
1
1
1
2