Brother International PR-600 Users Manual - English - Page 195

Sapphire.book Page 177 Friday, August 1, 2003 9:12 AM Remove the cap frame driver. 4 Align the holes on the embroidery frame holder 6 with the pins in the frame-mounting plate of the carriage. 1 2 Note ● Be careful that the cap frame driver does not hit any nearby parts, such as the presser foot. With the hole on the sweat guard holder 5 aligned with the centerline of the guiding plate, insert the two thumb screws removed in step 3 into the holes at the top, and then tighten the thumb screws. 3 3 1 Pins in the frame-mounting plate 2 Holes on the embroidery frame holder Secure the embroidery frame holder with the two 7 thumb screws. 1 2 1 Hole on the sweat guard holder 2 Centerline of guiding plate 3 Holes on the top • Insert the thumb screws into the holes where the cap frame driver that was originally installed (holes that the thumb screws were removed from in step 2 on page 170). X The movable section of the cap frame driver is secured. 1 Use the thumb screws included with the machine (thumb screws removed in step 1 on page 170). CAUTION ● Using the disc-shaped screwdriver included, firmly tighten the thumb screws. 7 Using the Optional Cap Frame 177