Brother International PR-600 Users Manual - English - Page 208
Symptom, Probable Cause, Remedy, Reference
View all Brother International PR-600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 208 highlights
Sapphire.book Page 190 Friday, August 1, 2003 9:12 AM Appendix Troubleshooting If the machine does not operate correctly, check for the following points/issues before requesting service. If the suggested remedy does not correct the problem, contact your authorized dealer. Symptom The embroidery machine does not operate. Probable Cause The machine is not turned ON. The machine has not been unlocked. The start/stop button was not pressed. Upper Tension dial is over tightened. The needle is not installed correctly. The needle set screw is loose. The needle is bent or blunt. The area around the hole in the needle plate is damaged. 1 Remedy Turn on the embroidery machine. Touch the unlock key. With the machine unlocked, press the start/stop button. Make sure tension disc rotates when pulling on thread. Correctly install the needle. Use the Allen screw driver to securely tighten the needle set screw. Replace the needle with a new one. Reference Page p.20 p.41 p.41 p.84 p.61 p.61 p.15, 61 Replace the needle plate. Consult your nearest authorized dealer. The needle breaks. 1 Scratches/Burrs The needle hits/touchs the needle plate. 12 3 1 Needle 2 Hole in needle plate 3 Needle hits hole The presser foot is set too high and not correctly positioned. The needle hits/touches the presser foot. Replace needle. Consult your nearest authorized dealer. Consult your nearest authorized dealer. 190