Brother International SE600 Operation Manual - Page 28
Using the foot controller
View all Brother International SE600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Sewing Set the fabric under the presser foot. Hold the fabric g and thread with your left hand, and rotate the handwheel counterclockwise or press (Needle position button) to set the needle in the sewing start position. Lower the presser foot lever. h Adjust the sewing speed with the sewing speed i controller. (when using utility stitches) You can use this controller to adjust sewing speed during sewing. b a 1 Fast 2 Slow CAUTION • Do not press (Thread cutter button) after the threads have been cut. Doing so could tangle the thread or break the needle and damage the machine. • Do not press (Thread cutter button) when there is no fabric set in the machine. The thread may tangle, possibly resulting in damage. Note • When cutting thread such as nylon monofilament thread, or other decorative threads, use the thread cutter on the left side of the machine. Press the "Start/Stop" button to start sewing. (When j the foot controller is plugged in, slowly press down on the foot controller.) Guide the fabric lightly by hand. Memo • When the foot controller is being used, you cannot start sewing by pressing the "Start/Stop" button. Press the "Start/Stop" button again to stop sewing. k (When the foot controller is plugged in, remove your foot from the foot controller.) Press (Thread cutter button) to trim the upper and l bobbin threads. → The needle will return to the up position automatically. When the needle has stopped moving, raise the presser m foot lever and remove the fabric. Check the sewing finish. If necessary, adjust the thread n tension. (page 29) ■ Using the foot controller You can also use the foot controller to start and stop sewing. Memo • When the foot controller is connected, you cannot use the "Start/Stop" button. • Bobbin winding can be started and stopped with the foot controller. • The foot controller cannot be used when embroidering. Turn off the machine. a Insert the foot controller plug into the foot controller b jack on the machine. 1 Foot controller jack 1 Turn on the machine. c 26