Brother International SE600 Operation Manual - Page 7

Names of Machine Parts 1 Chapter GETTING READY Names of Machine Parts ■ Main parts b cde a f g m l h k j n x w v i o p q r 0 Flat bed attachment (page 7, 31) A Thread cutter (page 19) B Needle threader lever (page 19) C Thread tension dial (page 29, 67) D Handwheel Turn the handwheel toward you (counterclockwise) to raise and lower the needle to sew one stitch. E Thread guide cover (page 14) F Handle Carry the machine by its handle when transporting. G Presser foot lever Raise and lower the presser foot lever to raise and lower the presser foot. H Feed dog position switch Use the feed dog position switch to raise and lower the feed dogs. (page 47) I Main power switch (page 9) J Power supply jack (page 9) K Foot controller (page 26) L Foot controller jack (page 26) M Air vent The air vent allows the air surrounding the motor to circulate. Do not cover the air vent while the machine is being used. N USB port (for a USB flash drive) (page 55, 75) O Embroidery unit (page 58) ■ Needle and presser foot section i a h b GETTING READY 1 s t u y 1 Bobbin winding thread guide and pretension disk (page 15) 2 Thread guide (page 14) 3 Spool cap (page 13) 4 Spool pin (page 13) 5 Hole for extra spool pin This holds an extra spool pin for sewing with twin needle. (page 52) This is not a hole for lubrication. Do not insert oil into this hole. 6 Bobbin winder (page 13) 7 LCD (liquid crystal display) (page 10) 8 Operation panel (page 6) 9 Operation buttons and sewing speed controller (page 6) g c f d e 1 Needle bar thread guide (page 18) 2 Needle plate (page 31) 3 Needle plate cover (page 16) 4 Bobbin cover/bobbin case (page 16, 78) 5 Feed dogs The feed dogs feed the fabric in the sewing direction. 6 Presser foot The presser foot applies pressure consistently on the fabric as the sewing takes place. Attach the appropriate presser foot for the selected stitch. 7 Presser foot holder (page 24) 8 Presser foot holder screw (page 24) 9 Buttonhole lever (page 42) 5