Brother International TD-4520TN Users Guide - Page 24

Loading the Media in Cutter mode Dealers only

Get Brother International TD-4520TN PDF manuals and user guides View all Brother International TD-4520TN manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

3.3.3 Loading the Media in Cutter mode (Dealers only) 1. Install the label roll as described in section 3.3.1. 2. Use the Brother Printer Management Tool to set the media sensor type and calibrate the selected sensor. 3. Open the Roll Compartment Cover by pressing the tabs located on each side of the printer. 4. Push the Print Head Release Button to open the Print Head mechanism and feed the media through the media sensor. Adjust the Media Guide Tips to fit the label width. 5. Push the media through the Cutter Output Slot. Note Make sure that the label print side is facing up. Media Guide Tips 20

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
20
3.3.3 Loading the Media in Cutter mode (Dealers only)
1.
Install the label roll as described in
section 3.3.1.
2.
Use the Brother Printer Management
Tool to set the media sensor type and
calibrate the selected sensor.
3.
Open the Roll Compartment Cover by
pressing the tabs located on each side of
the printer.
4.
Push the Print Head Release Button to
open the Print Head mechanism and
feed the media through the media
sensor. Adjust the Media Guide Tips to fit
the label width.
5.
Push the media through the Cutter
Output Slot.
Note
Make sure that the label print side is
facing up.
Media Guide Tips