Brother International TD-4520TN Users Guide - Page 26
Loading the Media in Peel-off Mode Dealers only
 |
View all Brother International TD-4520TN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Note Calibrate the Gap/Black Mark Sensor every time you change the installed media. 3.3.4 Loading the Media in Peel-off Mode (Dealers only) 1. Install the label roll as described in section 3.3.1. 2. Use the Brother Printer Management Tool to set the media sensor type and calibrate the selected sensor. 3. Open the Roll Compartment Cover by pressing the tabs located on each side of the printer. 4. Push the Print Head Release Button to open the Print Head mechanism and feed the media through the media sensor. Adjust the Media Guide Tips to fit the label width. 5. Pull the media out of the printer and remove some labels, leaving the liner only. Note Make sure that the label print side is facing up. Media Guide Tips Label Liner 22
-
1 -
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21 -
22 -
23 -
24 -
25 -
26 -
27 -
28 -
29 -
30 -
31 -
32
-
33
-
34
-
35
-
36
-
37
-
38
-
39
-
40
-
41
-
42
-
43
-
44
 |
 |
22
Note
Calibrate the Gap/Black Mark Sensor every time you change the installed media.
3.3.4 Loading the Media in Peel-off Mode (Dealers only)
1.
Install the label roll as described in
section 3.3.1.
2.
Use the Brother Printer Management
Tool to set the media sensor type and
calibrate the selected sensor.
3.
Open the Roll Compartment Cover by
pressing the tabs located on each side of
the printer.
4.
Push the Print Head Release Button to
open the Print Head mechanism and
feed the media through the media
sensor. Adjust the Media Guide Tips to fit
the label width.
5.
Pull the media out of the printer and
remove some labels, leaving the liner
only.
Note
Make sure that the label print side is
facing up.
Media Guide Tips
Liner
Label