Canon 2677B002 SX80 Manual - Page 130
Replacing the Lamp, As shown in the replace
View all Canon 2677B002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
Maintenance ■Replacing the Lamp 1 Turn off the projector, disconnect the power plug from the AC outlet, and let the projector stand for at least 1 hour. 2 As shown in the figure, insert a flat- head screwdriver in the gap and remove the lamp cover by raising it. 3 Loosen two screws with a philips-head screwdriver and then pull up the handle. * Pull up the handle as shown in the figure. 4 Remove the lamp while holding the center of the handle. 5 Fully insert a new lamp and secure it with two screws. * After the installation, be sure to push down the handle. 6 As shown in the figure, replace the lamp cover. Check whether the lamp cover is installed securely. 7 Turn on the projector. 8 Bring up the menu and select [System settings] -> [Other settings] -> [Lamp counter]. (P98) 9 Select [Reset] -> [OK] to reset the lamp counter. 130