Canon Digital Rebel Software Instructions EOS DSD Ver.6 - Page 92
To Display the Device Manager, I connected the camera to the computer before installing,
![]() |
UPC - 013803028997
View all Canon Digital Rebel manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
Troubleshooting ➞ If [EOS Kiss REBEL 300D] or [Canon Digital Camera] is displayed in [Other devices] or [Unknown devices], the driver was not installed correctly. Use the following procedure to re-install the driver. 1 Delete [EOS Kiss REBEL 300D] or [Canon Digital Camera] displayed in [Other devices] or [Unknown devices]. 2 Disconnect the dedicated USB cable and uninstall the driver. (W-84) 3 Re-install the driver. (W-4) To Display the Device Manager ● Windows XP ➞ Click the [Start] button and select [Control Panel] s [Performance and Maintenance] s [System]. Then select the [Hardware] tab and click the [Device Manager] button. ● Windows 2000 ➞ Click the [Start] button and select [Settings] s [Control Panel]. Then double-click the [System] icon to open and select the [Hardware] tab and click the [Device Manager] button. ● Windows Me and Windows 98 SE ➞ Click the [Start] button and select [Settings] s [Control Panel]. Then double-click the [System] icon to open and select the [Device Manager] tab. I connected the camera to the computer before installing the software ● Did you set the camera's power switch to ? ➞ If you did not set the camera's power switch to , proceed as follows: 1 Disconnect the dedicated USB cable from the camera and computer. 2 Install the SOLUTION DISK software on your computer using the correct installation procedure and then connect the camera to your computer to complete the installation. (W-4) ➞ If you set the camera's power switch to , proceed as follows: 1 If [Found New Hardware Wizard] or any other dialog boxes appear, click the [Cancel] buttons to cancel all the dialog boxes. 2 When you have canceled all the dialog boxes, set the camera's power switch to . 3 Disconnect the dedicated USB cable from the camera and computer. 4 Install the SOLUTION DISK software on your computer using the correct installation procedure and then connect the camera to your computer to complete the installation. (W-4) W-82
![](/manual_guide/products/canon-8861a003-software-instructions-eos-dsd-ver6-c55f052/92.png)