Canon MultiPASS C3000 User guide for the MPC3000. - Page 211
Print out any documents, The memory of
View all Canon MultiPASS C3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 211 highlights
Message CHECK PRINTER CLEAR PAPER JAM paper DOC TOO LONG LOAD PAPER MEMORY FULL NO RX PAPER NO TEL # Chapter 10 Error Code #003 #037 #012 #022 Cause Action There is an obstruction that is not allowing the cartridge mechanism to move right or left. There is a paper jam or the sheet feeder is empty. Check for a paper clip, paper jam, or the plastic orange cap off the BJ cartridge. Press STOP, and try your operation again. If the display does not change, try unplugging the unit. Wait several minutes, then plug it back in. Remove any paper from the sheet feeder. Clear the paper jam (see page 10-5). Then reload It took more than 32 minutes to send or copy a page. It took more than 32 minutes to receive a page. The document is longer than 39.4 inches (1 m). The MultiPASS is out of paper (the sheet feeder is empty). The memory of the MultiPASS is full because it has received too many documents, or a very long or detailed document. Memory is full because you tried to send too many pages at once, or a very long or detailed document. The other partys fax is out of paper. The one-touch or coded speed dialing number in the sheet feeder. Press RESUME or STOP. Divide the page and send or copy each part separately. Contact the other party. Have them divide the page and send each part separately. Use a copy machine to make a reduced copy of the document and send the copy. Load paper in the sheet feeder. Make sure the stack does not exceed the limit mark. Press RESUME or STOP. Print out any documents that are stored in memory. Then start the operation again. Divide the document into two or three jobs and send again; or send to one destination at a time. Contact the other party and have them install paper in their fax. Register the number (see page 3-18). Troubleshooting 10-9 Troubleshooting