Canon PC430 Service Manual - Page 130

CHAPTER 8 INSTALLATION II. UNPACKING AND INSTALLATION Moving a metal object from a cold to warm place can cause droplets of water to appear on its surface. The phenomenon is known as condensation, and condensation in the copier can trigger such problems as blank copies. If any such problem is expected, leave the copier alone at the site of installation at least one hour before unpacking it. Step Work Description 1 Open the shipping carton. 2 Take out the accessories. Make sure that the Operator's Manual is in the box. 3 Remove the cover bag from the copier, • Check the covers for damage and deformation caused and detach all strips of tape that hold during transit. parts. • Slide out the manual feed tray. • Slide out the delivery tray. 4 Move the copyboard to the left until it stops, and press the open/close button to open the copier's top cover. 5 Pull the two cardboard pieces, if found inside the copier at either end of the charging roller, straight up and out of the copier. Note: Do not touch the transfer charging roller inside the copier. Cardboard Cardboard 6 Take out the cartridge from the bag. (If the cartridge is installed in the copier, pull it out to the front.) Transfer charging roller 8-2 COPYRIGHT © 1998 CANON INC. CANON PC400/420/430,FC200/220 REV.0 JAN.1998 PRINTED IN JAPAN (IMPRIME AU JAPON)