Canon PIXMA MP800 Service Manual - Page 18
Repair, 3-1. Notes on Service Part Replacement
View all Canon PIXMA MP800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
3. REPAIR 3-1. Notes on Service Part Replacement (and Disassembling / Reassembling) Service part Notes on replacement*1 Adjustment / settings Operation check Logic board ass'y QM2-3022 - Before removal of the logic board ass'y, remove the power cord, and allow for approx. 1 minute (for discharge of capacitor's accumulated charges), to prevent damages to the logic board ass'y. - Before replacement, check the waste ink amount (by service test print or EEPROM information print). [See 3-4. Verification Items, (1) Service test print, or (2) EEPROM information print, for details.] After replacement: 1. Initialize the EEPROM. 2. Set the destination in the EEPROM. 3. Reset the waste ink counter. 4. Correct the CD / DVD and automatic print head alignment sensors. 5. Check the ink system function. 6. Adjust the line feeding. [See 3-3. Adjustment / Settings, (8) Service mode, for details of 1 to 6] 7. Perform the print head alignment in the user mode. - EEPROM information print - Service test print - Printing via USB connection - Copy - Direct printing from a digital camera Absorber kit QY5-0153 After replacement: 1. Reset the waste ink counter. [See 3.3. Adjustment / Settings, (8) Service mode.] - Service test print - EEPROM information print Carriage unit QM2-3025 At replacement: 1. Apply grease to the sliding portions. [See 3-3. Adjustment / Settings, (2) Grease application.] After replacement: 1. Correct the CD / DVD and automatic print head alignment sensors. [See 3.3. Adjustment / Settings, (8) Service mode.] 2. Check the ink system function. [See 3.3. Adjustment / Settings, (8) Service mode.] - Service test print (Confirm CD / DVD and automatic print head alignment sensor correction, and ink system function.) 3. Perform the print head alignment in the user mode. Paper feed motor QK1-1502 - The red screws securing the paper feed motor are allowed to be loosened. (DO NOT loosen any other red screws.) At replacement: 1. Adjust the paper feed motor. [See 3-3. Adjustment / Settings, (1) Paper feed motor adjustment.] Platen unit QM2-3026 At replacement: 1. Check the ink system function. [See 3.3. Adjustment / Settings, (8) Service mode.] - Service test print PR lift shaft ass'y: QL20936 At replacement: 1. Apply grease to the sliding portions. [See 3.3. Adjustment / Settings, (2) Grease application.] - Service test print Carriage lift base unit QM2-2232 At replacement: 1. Apply grease to the sliding portions. 1-13