Canon PIXMA iP6000D iP6000D Diect Print Guide - Page 85

Cannot Print Properly from the Digital Camera The following are the possible errors that may occur when printing directly from a digital still camera or digital video camcorder*, and the countermeasures to eliminate them. *Hereafter, the digital still camera and digital video camcorder are collectively called a digital camera or camera. Error message on camera Printer in use Printer warming up No paper Paper error Paper jam Printer cover open No print head Waste tank (ink absorber*2) full Ink is low Ink tank is empty Printer error Try This Photos are printed from the computer. Wait until printing ends. The printer automatically starts printing the photos from the camera after completing the current printing. Wait until warm-up ends. When it is ready, the printer starts printing automatically. Load paper in either the sheet feeder or cassette which you have selected with the paper feed switch on the printer, and select Continue*1 in the display on your camera. The paper output tray is closed. Open it to resume printing. If the inner cover is open, close it. Select Stop in the display on your camera to stop printing. Remove the jammed paper, load new paper, and press the RESUME button on the printer to resume printing. Close the cover on the printer. The POWER lamp on the printer flashes five times. No print head is installed. Install a print head according to the Quick Start Guide. When there is a print head installed, the print head is defective. Contact the Customer Care Center. The waste ink absorber*2 is nearly full. The printer has a built-in waste ink absorber to hold the ink used during print head cleaning. This error message indicates that the waste ink absorber is nearly full. You can continue printing for a while by selecting Continue*1 in the display on your camera. However, because printing is disabled once the waste ink absorber becomes completely full, you are recommended to contact the Customer Care Center as early as possible. It is about time to replace the ink tank with a new one. Select Continue*1 in the display on your camera to resume the printing. Printing resumes once the cover is closed after ink tank replacement. You can continue printing by selecting Continue*1 in the display on your camera with the ink tank empty. But, it is recommended you replace it with a new one immediately after printing. It may damage the printer if you continue printing with empty ink tanks. Select Stop in the display on your camera to stop printing. Disconnect the cable between the printer and the camera, turn off the printer, and unplug the power cord of the printer from the power supply. After a while, plug the power cord of the printer back in, turn on the printer, and then reconnect the camera to the printer. If the same error occurs, contact the Customer Care Center. 84