Canon VB-R12VE Network Camera Operation Guide - Page 100

[Basic] > [Date and Time] Setting the Date/Time Camera date and time settings. The following settings can be configured here. • Current Date and Time • Settings Current Date and Time The date and time set in the camera are displayed. Settings Set the date and time setting method, time zone and daylight saving time for the camera. [Settings Method] Select the date and time setting method. [Set manually] Set the desired date and time in [Date] and [Time]. Set the time in 24-hour format in order. [Synchronize with NTP server] Select the setting method displayed in [Set NTP Server Settings Automatically]. [Disable] Enter the IP address or host name of the NTP server in [NTP Server]. [Use DHCP] The camera time is synchronized with the time of the NTP server at the address acquired from the DHCP server. The acquired NTP server address is displayed in [NTP Server (DHCP)]. In order to set [Use DHCP], you must change [Network] > [IPv4] > [IPv4 Address Settings Method] to [Auto (DHCP)] (P. 95). [Use DHCPv6] The camera time is synchronized with the time of the NTP server at the address acquired from the DHCPv6 server. The acquired NTP server address is displayed in [NTP Server (DHCPv6)]. In order to set [Use DHCPv6], you must change [Network] > [IPv6] > [IPv6] to [Enable], then set [Auto (DHCPv6)] to [Enable] (P. 95). [Use DHCP/DHCPv6] The camera time is synchronized with the time of the NTP server at the address acquired from the DHCP server or DHCPv6 server. If the NTP server address can be acquired from both the DHCP server (IPv4) and DHCPv6 server, the NTP server address acquired from the DHCP server (IPv4) will be used. [Synchronization Interval (minutes)] Enter the synchronization interval for the specified NTP server. [Last Sync Time] The time last synchronized with the specified NTP server will be displayed. 100