Canon VB-R12VE Network Camera Operation Guide - Page 112

[Camera] > [Initial Settings] Setting Initial Video Settings Sets initial settings, such as video quality compensation, at camera start up. If you change settings, the changes are immediately reflected in the video display area and Viewer, even if you do not click [Apply]. A message confirms whether you want to display the current camera status as the initial settings if the current camera status differs from the settings registered as the initial settings when you access [Initial Settings]. If you click [OK], the current camera status is displayed as the initial settings. If you click [Cancel], the current camera status is ignored and the settings registered as the initial settings are displayed. The following settings can be configured here. • Camera Position • Camera Settings Camera Position Sets the camera position at camera start up. Important R1x M50 H76x If you change the zoom after configuring the intelligent function, privacy mask, preset, and ADSR, those settings must be configured again. Note After installing the camera, set the zoom position with the zoom slider in [Initial Settings]. H751 M74x [Pan/Tilt/Zoom position] R1x M50 Register the present pan, tilt, and zoom positions as the initial setting. You can operate the frame on the panorama screen or the video display area to perform pan, tilt, and zoom operations. If you select [Do Not Register], the camera will return to the pan, tilt, and zoom positions as when the camera was turned off the next time it is booted. Note M50 When [Digital PTZ Position] is set to [Do Not Register], you can perform pan, tilt, and zoom operations on the video display area using Area Zoom (P. 67). [Zoom Position] H76x Register the present zoom positions as the initial setting. If you select [Do Not Register], the camera will return to the zoom positions as when the camera was turned off the next time it is booted. 112