Canon VB-R12VE Network Camera Operation Guide - Page 142

1 Select [Enable] for the area with the frame color to use for the specified area. The frame for the specified area is displayed on the video display area. 2 Set the specified area. Set the specified area as follows within the display area. • Drag out a frame and move it to the area you want to specify. • Change the size of the frame by dragging any of the eight handles (■). • To change the camera angle, perform either of below R1x M50 H76x Control using the pan/tilt/zoom sliders ( H76x zoom only) Select a preset in the preset selection box 3 Click [Apply]. The settings are saved to the camera. Note You can use the Camera Viewer to check video with ADSR settings applied. Video outside the specified area will deteriorate according to the amount of applied data reduction. [Preview] R1x M50 The camera will move to a specified area if you click [Preview] for that area. Note R1x M50 H76x If you change the camera angle before operating the area frame, the area frame may become hidden. To display the area frame again, either click the [Preview] for the target specified area, or use the slider to move the camera angle to a position in which the entire area frame is displayed. ADSR Set the data size reduction of outside areas set with [Specified Area]. [Enable in H.264(1)] Select [Enable] to lower video quality of outside areas set with [Specified Area] in H.264(1) video. [Enable in H.264(2)] Select [Enable] to lower video quality of outside areas set with [Specified Area] in H.264(2) video. [Data Size Reduction Level] Set the data size reduction level for the outside area of [Specified Area]. If you select [Low], the data size reduction effect is lower. If you select [High], the data size reduction effect is higher. 142