Canon Vb-C60 NETWORK CAMERA VB-C60 Start Guide - Page 45

Initial setting is now complete.

Get Canon Vb-C60 - Ptz Network Camera PDF manuals and user guides
UPC - 013803118063
View all Canon Vb-C60 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 45 highlights

Initial Setting and Installation 4. A setup progress window appears and your settings will be saved 5. Click "OK" Step3 Initial Setting ● Set an appropriate IP address for your system. Contact your network administrator Note for advice on setting the IP address, subnet mask and gateway address. ● If you need to set the IP address from the DHCP server, firstly set a temporary fixed address using VB Initial Setting Tool, and then change the address setting method to "Auto (DHCP)" in "Network" (→ dOperation Guide P.1-8) in the setting page. ● If 20 minutes or more pass after the camera is turned on, the camera stops sending requests for IP address allocation and it cannot detect the IP address using VB Initial Setting Tool. In this case, turn the camera off then on again. ● To restore the factory default settings, refer to "Restoring the Factory Default Settings" in the Operation Guide (→ dOperation Guide P.5-14). Initial setting is now complete. 2-11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
2-11
Initial Setting and Installation
4.
A setup progress window appears and
your settings will be saved
Note
●
Set an appropriate IP address for your system. Contact your network administrator
for advice on setting the IP address, subnet mask and gateway address.
●
If you need to set the IP address from the DHCP server, firstly set a temporary
fixed address using VB Initial Setting Tool, and then change the address setting
method to “Auto (DHCP)” in “Network” (
→
d
Operation Guide P.1-8) in the setting
page.
●
If 20 minutes or more pass after the camera is turned on, the camera stops sending
requests for IP address allocation and it cannot detect the IP address using VB
Initial Setting Tool. In this case, turn the camera off then on again.
●
To restore the factory default settings, refer to “Restoring the Factory Default
Settings” in the Operation Guide (
→
d
Operation Guide P.5-14).
Step3 Initial Setting
5.
Click “OK”
Initial setting is now complete.