Canon ZR-850 ZR850 ZR830 Manuals - Page 82
Message, Explanation/Solution
UPC - 013803078152
View all Canon ZR-850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
82 Trouble? Message LOW INK LEVEL INK ABSORBER FULL • FILE ERROR • CANNOT PRINT! SET PRINT ORDER PRINTER ERROR PRINT ERROR HARDWARE ERROR COMMUNICATION ERROR PRINTER IN USE PAPER LEVER ERROR PRINTER COVER OPEN NO PRINTHEAD Explanation/Solution The ink cartridge needs to be replaced soon. Select [CONTINUE] to restart printing. Select [CONTINUE] to resume printing. Contact a Canon Service Center (refer to the list included with the printer) to replace the ink absorber. You attempted to print an image that was recorded with another camcorder, with a different compression, or was edited on a computer. No still image on the memory card has been marked with a print order. Cancel printing. Turn the printer off and then on again. Check the printer status. If the error still persists, refer to the printer's instruction manual and contact the appropriate customer support center or service center. Cancel printing, disconnect the USB cable and turn off the printer. After a while, turn the printer back on and reconnect the USB cable. Check the printer status. Cancel printing. Turn off the printer and turn it back on. Check the printer status. If the printer is equipped with a battery, it might be exhausted. In such case, turn off the printer, replace the battery and turn it back on. The printer is experiencing a data transfer error. Cancel printing. Disconnect the USB cable and turn off the camcorder and the printer. After a short while, turn them on again, set the camcorder to mode and restore the connection. If you attempted to print from a memory card that contains a large number of images, reduce the number of images. The printer is in use. Check the printer status. Paper lever error occurred. Adjust the paper selection lever to the proper position. Close the printer cover securely. No print head is installed in the printer or the print head is defective.