Canon imageCLASS MF6595cx imageCLASS MF6500 Series Starter Guide - Page 7

of the toner cartridge A and the protrusions on, Insert the toner cartridge so that the left edge

Page 7 highlights

5 Place the toner cartridge on a flat surface and pull the seal completely out. Set Up the Machine 7 Hold the toner cartridge by its handle. Insert the toner cartridge into the machine with the arrows (A) on the toner cartridge pointing toward the machine. Do not pull the seal out at an angle. - If toner is adhered on the removed seal, be careful that your hands or clothes do not get dirty from touching the toner. - If your hands or clothes get dirty from touching the toner, wash them immediately in cold water. Do not use hot water. If you do, the toner may be set permanently. 8 Insert the toner cartridge so that the left edge of the toner cartridge (A) and the protrusions on the right side of the toner cartridge (B, C) fit into the guides inside the machine. The blue plastic pull tab should be pulled up as illustrated in step 4. 6 Open the left cover. 

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34

5
5
Place the toner cartridge on a flat surface and
pull the seal completely out.
Do not pull the seal out at an angle.
If toner is adhered on the removed seal, be careful that
your hands or clothes do not get dirty from touching the
toner.
If your hands or clothes get dirty from touching the toner,
wash them immediately in cold water. Do not use hot
water. If you do, the toner may be set permanently.
6
Open the left cover.
7
Hold the toner cartridge by its handle. Insert the
toner cartridge into the machine with the
arrows (A) on the toner cartridge pointing
toward the machine.
8
Insert the toner cartridge so that the left edge
of the toner cartridge (A) and the protrusions on
the right side of the toner cartridge (B, C) fit into
the guides inside the machine. The blue plastic
pull tab should be pulled up as illustrated in
step 4.
Set Up the Machine