Canon imageCLASS MF7470 imageCLASS MF7400 Series Reference Guide - Page 57
Neatly place your originals with the side to be, copied face up into the original supply tray
View all Canon imageCLASS MF7470 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Before Using the Machine 1 Original and Paper 2 Copying 3 Sending and Receiving 4 Printing and Scanning 5 Network (imageCLASS 6 MF7480/MF7470 Only) Remote UI (imageCLASS 7 MF7480/MF7470 Only) System Settings 8 Maintenance 9 Troubleshooting 10 Appendix 11 2. Neatly place your originals with the side to be copied face up into the original supply tray. Place your originals into the feeder as far as they will go. If any dirt on the original scanning area is detected when the originals are placed in the feeder, the following screen appears. Even though streaks may appear on the copies, you can continue to scan your originals by pressing [Done]. It is recommended, however, that you open the feeder, clean the scanning area, and then close the feeder. The following screen will not appear once the scanning area is clean. For instructions on cleaning the original scanning area, see "Cleaning the Machine," on p. 9-2. Table of Contents Index Back Previous Next TOP - Do not add or remove originals while they are being scanned. - When scanning is complete, remove the originals from the original output area (A) to avoid paper jams. - When you are enlarging an LTR or STMT original onto 11" x 17" or LGL paper, place the original horizontally. - The scanned originals are output to the original output area in the order that they are fed into the feeder. - You can place different size originals together into the feeder if you set the Different Size Originals mode. (See "Different Size Originals," on p. 3-28.) - 11" x 17" and LGL originals must be placed horizontally on the feeder. 2-9