Canon imageFORMULA CR-180 CR-180 Instruction Manual - Page 30
Turning ON and OFF the Power
![]() |
View all Canon imageFORMULA CR-180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Chapter 2 Preparation Before Use Turning ON and OFF the Power Follow the procedures below to turn the scanner power ON and OFF. Turning ON the Power Be sure to turn the power of all connected SCSI devices ON before you turn the computer Important ON. 1 To turn ON the scanner, press the power switch. ON Jog Start Stop Important ● The LED above the Start button, flashes after you turn the power ON for a few seconds, then it remains lit. ● The eject pocket document sensor may make an incorrect detection when scanning starts if a bright outside light or fluorescent light is shining on the scanner's eject pocket when the scanner is turned on. If this happens, pull the flapper on the eject pocket all the way forward and then return it to cancel the incorrect full detection and then try scanning again. (See p. 44) ● If the scanner does not work, or the LED continues to flash, there is a problem with the scanner. Turn OFF the power, and contact your local retailer or a Canon service department. WARNING If you hear strange sounds, detect smoke or abnormal heat, sense a vibration, or smell odd odors around the scanner, turn OFF the power immediately and disconnect the power cord from the power outlet. Call for service immediately. Failure to do so, may cause a fire. 2 Turn ON your computer. 26
![](/manual_guide/products/canon-imageformula-cr180-cr180-instruction-manual-adc4d0b/30.png)