Canon imagePROGRAF PRO-6000 series User Manual - Page 117
holder stopper, so that there is a gap between the holder stopper and the paper.
View all Canon imagePROGRAF PRO-6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
remove the roll holder, push the roll paper into the back, reinstall the roll holder, and pass the roll paper to the back of the paper core. 3. Align right edge of roll paper to right edge of paper core while pulling on roll paper evenly, and secure with tape. 4. While making sure that roll paper is flat, secure left edge of roll paper to paper core with tape. Outward Winding Inward Winding Important • Secure the left and right edges of the roll paper with tape within 1.97 inches (50 mm) of the edges so that neither end of the roll paper lift up. • When rewinding heavyweight paper, use strong adhesive tape to fasten it. Otherwise, a rewinding problem may result. • If you use a paper core narrower than the paper to be wound, adjust the position of the holder stopper, so that there is a gap between the holder stopper and the paper. 5. Make sure the leading edge of the roll paper is not lifting up from the paper core, and if there are places lifting up, tape in additional places so that the paper does not lift up. 6. Push roll holder downward and check that roll holder is not lifting up. Outward Winding Inward Winding Important • If the roll holder lifts up, it may cause an error. 117