Canon imagePROGRAF PRO-6000 series User Manual - Page 120
Take-up, Rewind, Roll Holder Lock
View all Canon imagePROGRAF PRO-6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
6. Hold printed paper between output guide and roll unit, then tap Yes. The roll is now cut. Important • When cutting the roll paper, always hold the printed paper. If cut without holding the printed paper, the paper may fall to the floor and become soiled. 7. While holding trailing edge of printed paper, press Take-up or Rewind button to wind printed paper. Apply adhesive tape to the rewound paper to hold it in place, if necessary. Important • Be careful not to scratch the printed surface. 8. Change Roll Holder Lock switch on roll unit to release side. 9. Hold roll holder by its flanges (A), and remove from roll unit. 120
6.
Hold printed paper between output guide and roll unit, then tap
Yes
.
The roll is now cut.
Important
•
When cutting the roll paper, always hold the printed paper. If cut without holding the printed paper,
the paper may fall to the floor and become soiled.
7.
While holding trailing edge of printed paper, press
Take-up
or
Rewind
button to wind
printed paper.
Apply adhesive tape to the rewound paper to hold it in place, if necessary.
Important
•
Be careful not to scratch the printed surface.
8. Change
Roll Holder Lock
switch on roll unit to release side.
9.
Hold roll holder by its flanges (A), and remove from roll unit.
120