Canon imagePROGRAF TX-3000 MFP T36 imagePROGRAF TX-4000 / TX-3000 / TX-2000 Se - Page 11

Perform Print Head Adjustment and Select the Connection Method When the screen for selecting the connection method appears, select the connection method to use. • If you are connecting the printer to the network using a fixed IP Note address, select Do not connect. Configure the settings from the touch screen of the printer after the printer has finished charging the ink for the first time and adjusting the print head. Wired LAN connection Wireless LAN connection USB connection This is the method for connecting the printer to the network using a LAN cable. 1 Tap Wired LAN connection. Check the message about the connection method and tap Yes if there are no problems. 2 A message prompting you to connect the LAN cable appears. 3 Use the LAN cable to connect the wired LAN connector on the back of the printer to the hub port. This is the method for connecting the printer to the network without using a cable. 1 Tap Wireless LAN connection. Check the message about the connection method and tap Yes if there are no problems. 2 A message prompting you to set up the wireless LAN appears. 3 If you are configuring from a computer -> Tap Yes. If you are configuring from the printer -> Tap No. This is the method for connecting the printer to a computer using a USB cable. Only 1 printer can be connected. Do not connect the USB cable yet. 1 Tap USB connection. Check the message about the connection method and tap Yes if there are no problems. 4 Tap OK. The paper starts feeding, and then the printer automatically starts charging the ink for the first time and adjusting the print head. Charging the ink for the first time and adjusting the print head for the first time takes about 35 minutes. • Do not open the covers of the printer or turn the power off while the ink is charging for the first time and the print head adjustment is executing. Important • If you selected Do not connect, the connection settings and software installation will need to be performed separately. Note Proceed to "Connect to the Printer" on p.12. • Charging the system with ink fills the system from the ink tanks to the print head. In addition, cleaning is performed to keep the printer in optimal condition. This may cause the remaining ink indicator and maintenance cartridge capacity indicator to drop some amount. The starter ink tank is for first-time installation. It is recommended that you purchase replacement ink tanks quickly. Wired LAN connection Configure the printer and computer connection settings and install the software while the ink is charging for the first time and the print head is adjusting. Proceed to "Connect to the Printer" on p.12. Wireless LAN connection If you are configuring from a computer -> C onfigure the printer and computer connection settings and install the software while the ink is charging for the first time and the print head is adjusting. Proceed to "Connect to the Printer" on p.12. USB connection Configure the printer and computer connection settings and install the software while the ink is charging for the first time and the print head is adjusting. Proceed to "Connect to the Printer" on p.12. If you are configuring from the printer -> Configure the wireless LAN settings from the printer after the printer has finished charging the ink for the first time and adjusting the print head. Proceed to "Configure Wireless LAN Settings on the Printer" on p.13. 11