Canon imagePROGRAF TX-3000 MFP T36 imagePROGRAF TX-4000 / TX-3000 / TX-2000 Se - Page 7

Install the Ink Tanks Install the 5 ink tanks by following the instructions on the screen. 1 Instructions on ink tank installation are shown on the screen. Open the ink tank covers as instructed. 2 Release the ink tank lock lever for the color of ink to install. Pull the handle part (A) towards you while pressing the button at position (B). B A 3 Pull out the ink tank lock lever. Pull straight up. Pull towards you. Securely lay down at a position where it does not return when you release your hand. • Make sure the ink tank lock lever stays in the locked position. Important 4 Shake each ink tank gently 7 or 8 times before opening its pouch. 5 Open the pouch and remove the ink tank. A B 6 Mount the ink tank in the holder. Install with the ink holes facing down and the metal contacts facing away from you. • Failure to shake the ink tanks may result Important in reduced print quality because ink ingredients have settled on the bottom of the tank. • If the ink tank is cold, allow it to adjust to Note room temperature before attaching it to the printer. • Never touch the ink holes (A) Important or metal contacts (B). Touching these parts may cause stains, damage the ink tank, and affect print quality. • Avoid dropping the ink tank after removing it from the pouch. Otherwise, ink may leak and cause stains. • Do not remove ink tanks to shake them after they have been mounted. Doing so may cause ink to spill. • An ink tank cannot be mounted in the Important holder if it is not oriented correctly for the color. • Do not try to force an ink tank into the holder if it does not go in normally. Check the color indicated on the label and the ink tank orientation, and then try mounting the tank into the holder again. 7