Canon imagePROGRAF TX-3000 MFP T36 imagePROGRAF TX-4000 / TX-3000 / TX-2000 Se - Page 5

5 Affix the printer to the stand. Remove the alignment rod. Use an M4 Allen wrench to securely affix three M4 hex screws each on the left and right from the bottom of the supporting plate. • The removed alignment rod will be used when attaching the Important basket. Attach the Roll Unit • When using the roll unit -> Attach the roll unit to the stand by referring to the Roll Unit Setup Guide (separate manual). • When not using the roll unit -> Proceed to "Attach the Basket". Attach the Basket • When using the basket included with the stand -> Attach the basket to the stand by referring to the Printer Stand Setup Guide (separate manual). Proceed to "Attach the Basket". • When not using the basket -> Proceed to "Assemble the Stacker". Assemble the Stacker • When using the stacker -> Assemble the stacker by referring to the Stacker Setup Guide (separate manual). • When not using the stacker -> Proceed to "Turn On the Printer". Turn On the Printer 1 Open the top cover. 2 Pull up and remove the belt stopper (A). A • Keep the belt stopper you removed for future use. You Note will need them in case you move the printer to another location. • When you open the top cover, a cleaning brush is stored on the right side. Take it out and use it when cleaning inside the top cover. 5