Cisco 1230AG Configuration Guide - Page 11

AP Configuration - 1230 ap

Get Cisco 1230AG - Aironet - Wireless Access Point PDF manuals and user guides View all Cisco 1230AG manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

Section 1: SVP Cisco Wireless LAN Controllers with 1100, 1130, 1140, 1200, 1230, 1240, 1250 APs 2. In the navigation pane, click Interfaces. Verify that the proper IP addresses are assigned to the interfaces. 3. Under Interface Name click management. 4. Under DHCP Information, enter the IP address of the Primary DHCP Server. 5. Repeat this step for the ap-manager interface. 6. Click the Apply button and save the changes. AP Configuration All handsets operating on a given AP radio must have the same QoS setting. All APs supporting the handsets must be configured to enable the corresponding features. 1. Power-on and connect the APs to the network. Wait a few minutes for the APs to find the controller. 2. Verify the APs are associated to the WLC. 3. From the main menu, click Monitor. PN: 1725-36192-001_H 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
Section 1: SVP
Cisco Wireless LAN Controllers with 1100, 1130, 1140, 1200, 1230, 1240, 1250 APs
PN: 1725-36192-001_H
11
2.
In the navigation pane, click
Interfaces
. Verify that the proper IP
addresses are assigned to the interfaces.
3.
Under
Interface Name
click
management
.
4.
Under
DHCP Information
, enter the IP address of the
Primary DHCP
Server
.
5.
Repeat this step for the
ap-manager
interface.
6.
Click the
Apply
button and save the changes.
AP Configuration
All handsets operating on a given AP radio must have the same
QoS setting. All APs supporting the handsets must be configured to
enable the corresponding features.
1.
Power-on and connect the APs to the network. Wait a few minutes
for the APs to find the controller.
2.
Verify the APs are associated to the WLC.
3.
From the main menu, click
Monitor
.