Cisco 3845 Software Guide - Page 471

Chapter 26 Configuring Network Security with ACLs Configuring IPv4 ACLs This example uses a standard ACL to filter traffic coming into Server B from a port, permitting traffic only from Accounting's source addresses 172.20.128.64 to 172.20.128.95. The ACL is applied to traffic coming out of routed Port 1 from the specified source address. Switch(config)# access-list 6 permit 172.20.128.64 0.0.0.31 Switch(config)# end Switch# show access-lists Standard IP access list 6 10 permit 172.20.128.64, wildcard bits 0.0.0.31 Switch(config)# interface gigabitethernet0/1 Switch(config-if)# ip access-group 6 out This example uses an extended ACL to filter traffic coming from Server B into a port, permitting traffic from any source address (in this case Server B) to only the Accounting destination addresses 172.20.128.64 to 172.20.128.95. The ACL is applied to traffic going into routed Port 1, permitting it to go only to the specified destination addresses. Note that with extended ACLs, you must enter the protocol (IP) before the source and destination information. Switch(config)# access-list 106 permit ip any 172.20.128.64 0.0.0.31 Switch(config)# end Switch# show access-lists Extended IP access list 106 10 permit ip any 172.20.128.64 0.0.0.31 Switch(config)# interface gigabitethernet0/1 Switch(config-if)# ip access-group 106 in Numbered ACLs In this example, network 36.0.0.0 is a Class A network whose second octet specifies a subnet; that is, its subnet mask is 255.255.0.0. The third and fourth octets of a network 36.0.0.0 address specify a particular host. Using access list 2, the switch accepts one address on subnet 48 and reject all others on that subnet. The last line of the list shows that the switch accepts addresses on all other network 36.0.0.0 subnets. The ACL is applied to packets entering a port. Switch(config)# access-list 2 permit 36.48.0.3 Switch(config)# access-list 2 deny 36.48.0.0 0.0.255.255 Switch(config)# access-list 2 permit 36.0.0.0 0.255.255.255 Switch(config)# interface gigabitethernet0/1 Switch(config-if)# ip access-group 2 in Extended ACLs In this example, the first line permits any incoming TCP connections with destination ports greater than 1023. The second line permits incoming TCP connections to the Simple Mail Transfer Protocol (SMTP) port of host 128.88.1.2. The third line permits incoming ICMP messages for error feedback. Switch(config)# access-list 102 permit tcp any 128.88.0.0 0.0.255.255 gt 1023 Switch(config)# access-list 102 permit tcp any host 128.88.1.2 eq 25 Switch(config)# access-list 102 permit icmp any any Switch(config)# interface gigabitethernet0/1 Switch(config-if)# ip access-group 102 in For another example of using an extended ACL, suppose that you have a network connected to the Internet, and you want any host on the network to be able to form TCP connections to any host on the Internet. However, you do not want IP hosts to be able to form TCP connections to hosts on your network, except to the mail (SMTP) port of a dedicated mail host. OL-23400-01 Cisco ME 3800X and 3600X Switch Software Configuration Guide 26-23