Cisco 8540 User Guide - Page 32

Connecting Power to the Chassis - configuration guide

Get Cisco 8540 - Catalyst Campus Switch Router Modular Expansion Base PDF manuals and user guides View all Cisco 8540 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

Connecting Power to the Chassis Chapter 2 Installing the Chassis Step 2 Push the power supply into the power supply bay until the faceplate is flush with the cover. Note In a nonredundant configuration, install the power supply in the left power supply bay. Step 3 Tighten the captive installation screw by turning it clockwise. For power supply replacement information, see the "Replacing Power Supplies" section on page 3-2. Connecting Power to the Chassis This section describes the procedures for connecting AC and DC power to the chassis. This section contains the following topics: • Connecting the AC Power Supply • Connecting the DC Power Supply Note Install proper grounding to avoid damage from lightning and power surges. Connecting the AC Power Supply To connect power to an AC power supply, follow these steps: Step 1 Plug a power cord into the power cord connection of one AC power supply. (See Figure 2-5.) Catalyst 8540 Chassis Installation Guide 2-8 78-6134-03

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
Chapter 2
Installing the Chassis
Connecting Power to the Chassis
2-8
Catalyst 8540 Chassis Installation Guide
78-6134-03
Step 2
Push the power supply into the power supply bay until the faceplate is flush with
the cover.
Note
In a nonredundant configuration, install the power supply in
the left power supply bay.
Step 3
Tighten the captive installation screw by turning it clockwise.
For power supply replacement information, see the “Replacing Power Supplies”
section on page 3-2.
Connecting Power to the Chassis
This section describes the procedures for connecting AC and DC power to the
chassis. This section contains the following topics:
•
Connecting the AC Power Supply
•
Connecting the DC Power Supply
Note
Install proper grounding to avoid damage from lightning and
power surges.
Connecting the AC Power Supply
To connect power to an AC power supply, follow these steps:
Step 1
Plug a power cord into the power cord connection of one AC power supply. (See
Figure 2-5.)