Cisco 8540 User Guide - Page 41
Removing the AC Power Supply
View all Cisco 8540 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Chapter 3 Maintaining the Chassis Replacing Power Supplies Removing the AC Power Supply To remove an AC power supply, follow these steps: Step 1 Turn off the power switch on the power supply you are removing. (See Figure 3-1.) Caution Failure to turn off the AC power supply could result in equipment damage. Figure 3-1 AC Power Supply Power cord connection 33014 Power switch INPUT OK FAN OUTPUT OK FAIL Step 2 Step 3 Step 4 Step 5 Captive screw Disconnect the AC power cord from the input line. Remove the input power cord from the power cord connection. Loosen the captive installation screw on the power supply with a screwdriver. (See Figure 3-1.) Grasp the power supply handle with one hand. Slowly pull the power supply out of the chassis toward you. While holding the power supply handle with one hand, place your other hand underneath to support the bottom of the supply. (See Figure 3-2.) 78-6134-03 Catalyst 8540 Chassis Installation Guide 3-3