Cisco ASR1000-RP2 Software Guide - Page 306
Step 3, value 1 refers to
View all Cisco ASR1000-RP2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 306 highlights
Configuring Synchronous Ethernet Chapter 10 Synchronous Ethernet Support Step 3 Step 4 Command Purpose network-clock synchronization automatic Enables the network clock selection algorithm. This command disables the Cisco-specific network clock Example: Router(config)# network-clock process, and turns on the G.781-based automatic clock selection process. synchronization automatic network-clock synchronization ssm option {option_id {GEN1 | GEN2}} Example: Router(config)# network-clock synchronization ssm option 2 GEN1 Configures the equipment to work in a synchronization network. The option_id value 1 refers to a synchronization networks design for Europe. This is the default value. The option_id value 2 refers to a synchronization networks design for the U.S. Step 5 interface gigabitethernet slot/port Step 6 Example: Router(config)# int gig 0/0/0 synchronous mode Specifies the Gigabit Ethernet interface to be configured: slot/port-Specifies the location of the interface. Sets the mode to synchronous mode. Step 7 Example: Router(config-if)# synchronous mode exit Exits the specific configuration mode. Step 8 Example: Router(config)# exit network-clock output-source line priority {interface interface_name} {external slot/card/port} Configures the line clock to be used on external Tx interfaces. Example: Router(config-if-srv)# encapsulation dot1q 40 second-dot1q 42 Step 9 exit Exits the global configuration mode. Example: Router(config)# exit 10-10 Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide OL-16506-10