Cisco ASR1000-RP2 Software Guide - Page 369
After the switchover, the user must log onto RP0., The remaining commands are all entered from RP0
View all Cisco ASR1000-RP2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 369 highlights
Appendix B Configuration Examples ISSU-Consolidated Package Upgrade OL-16506-10 Router# issu loadversion rp 0 file stby-bootflash:asr1000rp1-adventerprisek9.02.01.01.122-33.XNA1.bin --- Starting installation state synchronization --Finished installation state synchronization --- Starting file path checking --Finished file path checking --- Starting system installation readiness checking --Finished system installation readiness checking --- Starting installation changes --Setting up image to boot on next reset Starting automatic rollback timer Finished installation changes SUCCESS: Software will now load. Router# *Jul 21 23:53:41.218: %ASR1000_OIR-6-OFFLINECARD: Card (rp) offline in slot R0 *Jul 21 23:53:41.256: %REDUNDANCY-3-STANDBY_LOST: Standby processor fault (PEER_NOT_PRESENT) *Jul 21 23:53:41.256: %REDUNDANCY-3-STANDBY_LOST: Standby processor fault (PEER_DOWN) *Jul 21 23:53:41.256: %REDUNDANCY-3-STANDBY_LOST: Standby processor fault (PEER_REDUNDANCY_STATE_CHANGE) *Jul 21 23:53:42.423: %IP-4-DUPADDR: Duplicate address 172.29.52.155 on GigabitEthernet0, sourced by 001a.3046.e3ff *Jul 21 23:56:19.885: %ASR1000_OIR-6-ONLINECARD: Card (rp) online in slot R0 *Jul 21 23:56:39.324: %REDUNDANCY-5-PEER_MONITOR_EVENT: Active detected a standby insertion (raw-event=PEER_FOUND(4)) *Jul 21 23:56:39.324: %REDUNDANCY-5-PEER_MONITOR_EVENT: Active detected a standby insertion (raw-event=PEER_REDUNDANCY_STATE_CHANGE(5)) *Jul 21 23:58:03.660: %HA_CONFIG_SYNC-6-BULK_CFGSYNC_SUCCEED: Bulk Sync succeeded *Jul 21 23:58:03.661: %RF-5-RF_TERMINAL_STATE: Terminal state reached for (SSO) Router# issu runversion --- Starting installation state synchronization --Finished installation state synchronization Initiating active RP failover SUCCESS: Standby RP will now become active Router# System Bootstrap, Version 12.2(33r)XN2, RELEASE SOFTWARE (fc1) Technical Support: http://www.cisco.com/techsupport Copyright (c) 2008 by cisco Systems, Inc. After the switchover, the user must log onto RP0. The remaining commands are all entered from RP0: Router# issu acceptversion Cancelling rollback timer SUCCESS: Rollback timer cancelled Router# issu commitversion Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide B-25