Cisco C8510MSR-SKIT-DC Getting Started - Page 5

Installing the MCU MSE 8510 Installing the MCU MSE 8510 Important: Before installing the MCU MSE 8510 into the MSE 8000, read the safety information guide for the MSE 8000 chassis at http://www.cisco.com/go/telepresence/safety. ! Although blades are hot-swappable parts, you must only remove one blade at any time. Remove the power from the MSE 8000, if you need to remove more than one blade at a time. Before hot-swapping a blade, shut down the blade using the web interface. ! Do not shut down a blade during a software upgrade or if the blade is processing (for example if a conference is taking place on a blade). The MSE 8000 backplane uses high performance data connectors. Do not ! remove MCU MSE 8510 blades unless necessary because doing so may reduce the life of these connectors. ! Make sure that you have the correct power requirements and sufficient power in your PSU; for information on powering the MSE 8000 refer to the Getting Started Guide on http://www.tandberg.com/support/video- conferencing-documentation.jsp). Step one: Install the MCU MSE 8510 into the MSE 8000 chassis ! You must install either a blade or a blanking blade in each of the ten positions in the chassis. ! The Supervisor blade must be installed into slot 1 of the MSE 8000 chassis. 1 Remove the blade or blanking blade from the slot into which you are going to install the MCU MSE 8510: i Using a No.1 Phillips screwdriver, loosen the screws in the retaining latches with an anti-clockwise quarter turn. ii Open both retaining latches on the front of the blade or blanking blade. When open, a retaining latch is at a 90° angle perpendicular to the front of the blade. 5