Cisco CSACS-1121-K9 Reference Guide - Page 118
show ports, Table A-12, Output Modifier Variables for Count or Last
View all Cisco CSACS-1121-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
Show Commands Appendix A ACS Command Reference show ports To display information about all the processes listening on active ports, use the show ports command in the EXEC mode. show ports [|] [|] Syntax Description | Output modifier variables: • begin-Matched pattern. Up to 80 alphanumeric characters. • count-Count the number of lines in the interface. Add number after the word count. |-Output modifier variables (see Table A-12). • end-End with line that matches. Up to 80 alphanumeric characters. • exclude-Exclude lines that match. Up to 80 alphanumeric characters. • include-Include lines that match. Up to 80 alphanumeric characters. • last-Display last few lines of output. Add number after the word last. Up to 80 lines to display. Default 10. |-Output modifier variables (see Table A-12). Table A-12 | Output Modifier Variables for Count or Last Output modifier variables: • begin-Matched pattern. Up to 80 alphanumeric characters. • count-Count the number of lines in the output. Add number after the word count. |-Output modifier variables. • end-End with line that matches. Up to 80 alphanumeric characters. • exclude-Exclude lines that match. Up to 80 alphanumeric characters. • include-Include lines that match. Up to 80 alphanumeric characters. • last-Display last few lines of output. Add number after the word last. Up to 80 lines to display. Default 10. |-Output modifier variables. Defaults No default behavior or values. Command Modes EXEC Usage Guidelines When you run the show ports command, the port must have an associated active session. A-80 CLI Reference Guide for the Cisco Secure Access Control System 5.1 OL-18996-01