Cisco CSACS-1121-K9 Reference Guide - Page 166

Configuration Commands Appendix A ACS Command Reference Command Modes Configuration. Examples acs/admin(config)# ip route 192.168.0.0 255.255.0.0 gateway 172.23.90.2 kron occurrence To schedule one or more Command Scheduler commands to run at a specific date and time or a recurring level, use the kron occurrence command in Configuration mode. To delete this, use the no form of this command. kron {occurrence} occurrence-name Syntax Description occurrence occurrence-name Schedules Command Scheduler commands. Name of the occurrence. Up to 80 alphanumeric characters. (See following note and Syntax Description.) Note After you enter the occurrence-name in the kron occurrence command, you enter the config-occurrence configuration submode (see the following Syntax Description). at do end exit no policy-list recurring Identifies that the occurrence is to run at a specified calendar date and time. Usage: at [hh:mm] [day-of-week | day-of-month | month day-of-month]. EXEC command. Allows you to perform any EXEC commands in this mode (see do, page A-118). Exits the kron-occurrence configuration submode and returns you to the EXEC mode. Exits the kron-occurrence configuration mode. Negates the command in this mode. Three keywords available: • at-Usage: at [hh:mm] [day-of-week | day-of-month | month day-of-month]. • policy-list-Specifies a policy list to be run by the occurrence. Up to 80 alphanumeric characters. • recurring-Execution of the policy lists should be repeated. Specifies a Command Scheduler policy list to be run by the occurrence. Identifies that the occurrences run on a recurring basis. Defaults No default behavior or values. A-128 CLI Reference Guide for the Cisco Secure Access Control System 5.1 OL-18996-01