Cisco CSACS-1121-K9 Reference Guide - Page 161
interface, interface GigabitEthernet
View all Cisco CSACS-1121-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 161 highlights
Appendix A ACS Command Reference Configuration Commands Command Modes Configuration Usage Guidelines None. Examples acs/admin(config)# icmp echo off acs/admin(config)# Related Commands Command show icmp-status Description Display ICMP echo response configuration information. interface To configure an interface type and enter the interface configuration mode, use the interface command in Configuration mode. This command does not have a no form. interface GigabitEthernet [0 | 1] Syntax Description GigabitEthernet 0 | 1 Configures the Gigabit Ethernet interface. Number of the Gigabit Ethernet port to configure. Note After you enter the Gigabit Ethernet port number in the interface command, you enter the config-GigabitEthernet configuration submode (see the following Syntax Description). do end exit ip no shutdown EXEC command. Allows you to perform any EXEC commands in this mode (see do, page A-118). Exits the config-GigabitEthernet submode and returns you to the EXEC mode. Exits the config-GigabitEthernet configuration submode. Sets the IP address and netmask for the Ethernet interface (see ip address, page A-124). Negates the command in this mode. Two keywords available: • ip-Sets the IP address and netmask for the interface. • shutdown-Shuts down the interface. Shuts down the interface (see shutdown, page A-137). Defaults No default behavior or values. OL-18996-01 CLI Reference Guide for the Cisco Secure Access Control System 5.1 A-123