Cisco CSACS-1121-K9 Reference Guide - Page 171

Appendix A ACS Command Reference Configuration Commands To verify that ACS processes are running, use the 'show application status acs' command. acs/admin(config)# Related Commands Command show ntp Description Displays the status information about the NTP associations. password-policy To enable or configure the passwords on the system, use the password-policy command in Configuration mode. To disable this function, use the no form of this command. password-policy option Note The password-policy command requires a policy option (see Syntax Description). You must enter the password-expiration-enabled command before the other password-expiration commands. Syntax Description Note After you enter the password-policy command, you enter the config-password-policy configuration submode. digit-required Requires a digit in the password. disable-repeat-characters Disables the password's ability to contain more than four identical characters. disable-cisco-password Disables the ability to use the word Cisco or any combination as the password. lower-case-required Requires a lowercase letter in the password. min-password-length Specifies a minimum number of characters for a valid password. Integer length from 0 to 4,294,967,295. no-previous-password Prevents users from reusing a part of their previous password. no-username Prohibits users from reusing their username as a part of a password. password-expiration-days Number of days until a password expires. Integer length from 0 to 80. password-expiration-enabled Enables password expiration. Note You must enter the password-expiration-enabled command before the other password-expiration commands. password-expiration-warning Number of days before expiration that warnings of impending expiration begin. Integer length from 0 to 4,294,967,295. password-lock-enabled Locks a password after several failures. OL-18996-01 CLI Reference Guide for the Cisco Secure Access Control System 5.1 A-133