Cisco RV016 Administration Guide - Page 106

7 Configuring Access Rules After you click Add New Rule or the Edit icon on the Access Rules table, enter the following information on the add/edit page. NOTE Before navigating away from this page, click Save to save your settings. When the Success message appears, click OK to remain on the current page to add another access rule, or click Cancel to return to the Access Rules table. To undo your changes on this page, click Cancel. Any unsaved changes are abandoned. Services (IPv4 and IPv6) • Action: Choose the action that the rule performs, to Allow or Deny access. • Service: Choose the service that is affected by this rule. If you need to add a service, click Service Management. For more information, see Adding a service, page 108. • Log: To include events for this rule in the log, click Log packets match this rule. Otherwise, click Not log. This setting is applicable when logging is enabled. For more information, see Chapter 10, "Logging System Statistics.". • Source Interface: Choose the source interface that is affected by this rule. • Source IP (IPv4) or Source IP / Prefix Length (IPv6): Identify the source of the traffic that is affected by this rule. From the drop-down list, choose one of the following options: - Single: This rule applies to a single IP address. Enter the IP address. Cisco Small Business RV0xx Series Routers Administration Guide 106