Cisco SPA122 Administration Guide - Page 80
Control Timer Values sec, Ring Voltage: 80Vc
View all Cisco SPA122 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Configuring Voice Configuring Voice Settings 4 - Ring Frequency: 25 - Ring Voltage: 80Vc Field Description Ring Waveform Waveform for the ringing signal. Choices are Sinusoid or Trapezoid. Default setting: Sinusoid. Ring Frequency Frequency of the ringing signal. Valid values are 10-100 (Hz) Default setting: 20. Ring Voltage Ringing voltage. Choices are 60-90 (V) Default setting: 85. CWT Frequency Frequency script of the call waiting tone. All distinctive CWTs are based on this tone. Default setting: 440@-10. Synchronized Ring If this is set to Yes, when the ATA is called, all lines ring at the same time (similar to a regular PSTN line) After one line answers, the others stop ringing. Default setting: no. Control Timer Values (sec) Field Hook Flash Timer Min Hook Flash Timer Max Callee On Hook Delay Reorder Delay Call Back Expires Description Minimum on-hook time before off-hook qualifies as hookflash. Less than this the on-hook event is ignored. Range: 0.1-0.4 seconds. Default setting: 0.1. Maximum on-hook time before off-hook qualifies as hookflash. More than this the on-hook event is treated as onhook (no hook-flash event) Range: 0.4-1.6 seconds. Default setting: 0.9. Phone must be on-hook for at this time in sec. before the ATA will tear down the current inbound call. It does not apply to outbound calls. Range: 0-255 seconds. Default setting: 0. Delay after far end hangs up before reorder tone is played. 0 = plays immediately, inf = never plays. Range: 0-255 seconds. Default setting: 5. Expiration time in seconds of a call back activation. Range: 0-65535 seconds. Default setting: 1800. Cisco SPA100 Series Phone Adapters Administration Guide 80