Cisco SRST User Guide - Page 38
show voice register, getmany, Step 2 - config
UPC - 882658171475
View all Cisco SRST manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Configuration Chapter 1 Cisco SRST SNMP MIB Support Step 2 Step 3 Step 4 Step 5 Issue the following CLI command: Show voice register pool Verify the show voice register response is similar to the following: SRST-Router#sh voice regi pool 1 Pool Tag 1 Config: Network address is 1.4.196.0, Mask is 255.255.255.0 Proxy Ip address is 1.4.196.1 DTMF Relay is disabled Dialpeers created: dial-peer voice 40001 voip destination-pattern 5001 redirect ip2ip session target ipv4:1.4.196.41:25672 session protocol sipv2 dial-peer voice 40002 voip destination-pattern 5001 redirect ip2ip session target ipv4:1.4.196.1:5060 session protocol sipv2 monitor probe rtr 1.4.196.1 dial-peer voice 40003 voip destination-pattern 5002 redirect ip2ip session target ipv4:1.4.196.41:25672 session protocol sipv2 dial-peer voice 40004 voip destination-pattern 5002 redirect ip2ip session target ipv4:1.4.196.1:5060 session protocol sipv2 monitor probe rtr 1.4.196.1 Statistics: Active registrations : 4 Total Registration Statistics Registration requests : 4 Registration success : 4 Registration failed : 0 unRegister requests : 0 unRegister success : 0 unRegister failed : 0 Issue the following SNMP request: Getmany -v2c test csrstSipEndpointTable Verify the response for the getmany request is similar to the following: moki:1919> getmany -v2c 1.4.196.1 test csrstSipEndpointTable csrstSipVoRegPoolEdptTag.0 = 1 csrstSipVoRegPoolEdptTag.1 = 1 csrstSipVoRegPoolEdptTag.2 = 1 csrstSipVoRegPoolEdptTag.3 = 1 csrstSipEndpointIpAddrType.0 = ipv4(1) csrstSipEndpointIpAddrType.1 = ipv4(1) 1-24 Cisco SRST SNMP MIB Release 3.4 Guide OL-7959-01